CISCO CCIE 350-027
Visited 921 times, 3 so far today
CCIE Written: Metro Ethernet : 350-027 Exam
Exam Number/Code: 350-027
Exam Name: CCIE Written: Metro Ethernet
QUESTION 1:
Which statements are true regarding ATM-Ethernet PW Interworking? Select two. A. IP Interworking is supported.
B. Ethernet Interworking is supported.
C. LLC Interworking is supported.
D. ATM-Ethernet Interworking is not possible. Answer: A, B
Explanation: See Table 1 at:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1838/products_feature_guide09186a008029b264.html
QUESTION 2:
To eliminate the need for adjacent routers on broadcast networks to form n(n-1)/2 adjacencies, IS-IS
defines a pseudonode or Designated intermediate System, DIS. All router on the broadcast medium form
an adjacency with the DIS. The Backup DIS is called:
A. Redundant DIS B. BDR
C. There is no concept of a backup DIS in IS-IS D. Designated Redundant System
Answer: C Explanation:
1) http://www.cisco.com/warp/public/97/DIS-LSP-1.html
“On broadcast multi-access networks, a single router is elected as the DIS. There is no backup DIS elected. The
DIS is the router that creates the pseudonode and acts on behalf of the pseudonode.”
2) http://www.cisco.com/warp/public/97/is-is-ip-config.html
“Notice that the DIS is elected for both levels, and that no backup DIS exists, as with Open Shortest Path First
(OSPF), which has a backup Designated Router (DR).”
3) http://www.ciscopress.com/articles/article.asp?p=31319&rl=1
“No backup DIS exists in IS-IS, in contrast to the backup DR for OSPF. If a DIS dies, a new election takes place”
QUESTION 3:
What ISDN timer is started after Q.931 SETUP msg is sent? A. T301
B. T303
TK
350-027
C. T302
D. T310
E. T305
Answer: D Explanation:
If the Call Setup message is not acknowledged before the T303 timer expires, the CPE sends a second Call Setup message and restart T303. If T303 expires a second time, the call is cleared and disconnected.
Incorrect Answers:
T301 timer is for “Call Proceeding” not SETUP.
QUESTION 4:
Which statements are true regarding Interworking? Select two. A. Interworking is only supported in AToM.
B. Interworking is supported in AToM and L2TPv3.
C. Ethernet Interworking is only supported if one AC is Ethernet or VLAN. D. FR-PPP is not supported.
Answer: B, C Explanation:
Table1 L2VPN Interworking Supported Features
Feature MPLS or L2TPv3 Support IP or Ethernet Support
Frame Relay to Ethernet/VLAN MPLS L2TPv3
IP Ethernet
Frame Relay to PPP MPLS L2TPv3
IP
Frame Relay to ATM AAL5 MPLS IP Ethernet/VLAN to ATM AAL5 MPLS IP Ethernet
Ethernet to VLAN MPLS L2TPv3
IP Ethernet
http://www.cisco.com/en/US/partner/products/sw/iosswrel/ps1838/products_feature_guide09186a008029b264. html#wp107
Item “C” just means that to support Ethernet one end or the other of the Attachment Circuit has to
be Ethernet. Note that in the third column where “Ethernet” appears, one or the other (or both) in column 1 is “Ethernet” (or VLAN).
TK
350-027
Look for any Transport over MPLS for information on configuring AToM.
For configuring L2VPN Interworking, see L2VPN Interworking.
QUESTION 5:
Observering the output below from the CK router, select what path EoMPLS will take before exiting a router:
CK#show mpls 12transport vc 100 detail
Local interface: Fa0/0.1 up, line protocol up, Eth VLAN 100 up Destination address: 172.0.0.3, VC ID: 100, VC status: up Preferred path: Tunnel1, active
Default path: disabled
Tunnel label: 3, next hop point2point
Output interface: Tu1, imposed label stack {27 20} Create time: 00:07:11, last status change time: 00:07:11
Signaling protocol: LDP 16, remote 20
MPLS VC labels: local 16, remote 20
Group ID: local 0, remote 0
MTU: local 1500, remote 1500
Remote interface description:
Sequencing: receive disabled, send disabled
A. 172.0.0.3
B. FastEthernet 0/0
C. FastEthernet 0/0.1
D. Tunnel1
E. This is an invalid output
Answer: D
QUESTION 6:
What is NOT true regarding PW QoS?
A. A policy action can be applied for packets matched by DLCI.
B. LLQ can be applied to traffic classified per COS on Ethernet AC.
C. CB-WFQ can be applied to traffic classified per COS on Ethernet AC. D. The command ’set cos’ is used to modify the .1p cos bits in a policy.
E. The command ’set vlan’ is used to modify the VLAN tag in a policy. F. All of the above.
Answer: E
QUESTION 7:
According to the IEEE 802.3 CSMA/CD specification, what is the proper signal for contact 6 of a PHY
“CCIE Written: Metro Ethernet”, also known as 350-027 exam, is a Cisco certification.
Preparing for the 350-027 exam? Searching 350-027 Test Questions, 350-027 Practice Exam, 350-027 Dumps?
Note: This exam has been retired by Cisco.
As of February 1, 2007, the eight previously-available written exams will no longer be used to qualify a candidate for the lab exam. Four of them, however, will continue to be available for recertification purposes. The recertification exams are: CCIE SP Cable Exam (#350-021), CCIE SP Content Networking Exam (#350-026), CCIE SP Optical Exam (#350-020) and CCIE SP WAN Switching Exam (#350-023).
The four exams that are being retired are CCIE SP Dial Exam (#350-025), CCIE SP IP Telephony Exam (#350-024), CCIE SP DSL Exam (#350-022) and CCIE SP Metro Ethernet Exam (#350-027).
Interactive Testing Engine Included!
253 Questions
Updated : 03/04/2008
Price : $131.99 $119.99
Preparing for the 350-027 exam? Searching 350-027 Test Questions, 350-027 Practice Exam, 350-027 BrainDumps? Testking 350-027 is written to coincide with the real test by the experienced IT experts and specialists. With the complete collection of Testking Questions and Answers, Testking 350-027 is high enough to help the candidates to pass this exam easily without any other study materials and no need to attend the expensive training class.
Why choose Testking 350-027 braindumps
Quality and Value for the 350-027 Exam
100% Guarantee to Pass Your 350-027 Exam
Practice Test Questions accompanied by exhibits
Testking 350-027 Exam Features
Downloadable, Testking Interactive 350-027 Testing engines
Testking Cisco 350-027 Downloadable, Printable Exams (in PDF vce format)
Our Exam 350-027 Preparation Material Lbas provides you everything you will need to take your 350-027 exams. The 350-027 study guide Exam details Tutorials are researched and produced by Professional Certification Experts who are constantly using industry experience to produce precise, and logical. You may get questions from different web sites or books, but logic is the key. Our Product will help you not only pass in the first try, but also save your valuable time.
Free download?testking CCIE 350-027
Free download?pass4sure CCIE 350-027
Dowload PassGuide Practice Test Questions
10 Comments on “CISCO CCIE 350-027”